Humminbird 530516-1_D warranty Connecting the Cable

3

Quick Disconnect Mounting Bracket

4. Connecting the Cable

1.Insert the cable connector into the appropriate slots of the connector holder. The cable connectors are labeled, and there are corresponding labels on the connector holder on the rear of the fishfinder. The slots are keyed to prevent reversed installation, so be careful not to force the connector into the holder.

2.Carefully pull the excess cable from beneath the mounting surface so the connector holder aligns with the mounting holes on the front of the mounting bracket.

3.Snap the support plate to the rear of the connector holder as illustrated.

4.Insert the connector holder into place and use the two #6-32 x 3/4” screws to fasten it to the mounting bracket.

Snap the Support Plate onto	Attach the Connector Holder
the Connector Holder	to the Mounting Bracket

Support

Plate

5.Install the control head by sliding it onto the mounting bracket until it is fully seated. To remove the unit, simply depress the latch on the rear of the unit and lift.

6.If the cables pass outside the mounting bracket, reinstall the hole cover over the thru-hole and fasten in place using the two #8 x 7/8” wood screws.

530516-1_D

Cable Connector Holder

TransducerAccessory

CommunicationsPower

Connector Holder

Cable Connector

Your fishfinder is now ready for operation.

Firmly Press

Latch to

Remove Unit

© 2008 Humminbird®, Eufaula AL, USA. All rights reserved.