Manuals / Humminbird / Marine Equipment / Fish Finder

Humminbird MATRIX 12, MATRIX 37 Surface Clutter, Advanced, To change the Depth Lines setting

Models: Matrix 20 MATRIX 37 Matrix 10 Matrix 27 MATRIX 17 MATRIX 12

1 31

Download 31 pages 15.56 Kb

Page 20

Depth Lines

(Advanced)

Depth Lines divide the display into four equal sections which are separated by three horizontal depth lines. The depth of each line is displayed along the depth scale. You can either turn Depth Lines On or Off. The Depth Lines menu choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).

Depth Lines

Depth Lines

To change the Depth Lines setting:

1.Make sure you are in Advanced User Mode, then highlight Depth Lines on the Sonar main menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to turn the Depth Lines setting On or Off. (Off, On, Default = On)

Surface Clutter

(Advanced)

Surface Clutter adjusts the filter that removes surface clutter noise caused by algae and aeration. The lower the setting, the less surface clutter will be displayed. The Surface Clutter menu choice is available when User Mode is set to Advanced (see Setup Menu Tab: User Mode).

Surface Clutter

To change the Surface Clutter setting:

1.Make sure you are in Advanced User Mode, then highlight Surface Clutter on the Sonar main menu.

2.Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Surface Clutter setting. (Low = 1 to High = 10, Default = 5)

33

34

Image 20

Humminbird MATRIX 12, MATRIX 37, Matrix 20, MATRIX 17 manual Surface Clutter, Advanced, To change the Depth Lines setting

Contents

Operations Manual Table of Contents Thank YouAlarms Menu Tab Setup Menu TabAccessories Menu Tab Troubleshooting Sonar Menu TabHow Sonar Works Single Beam SonarDualBeam Plus Sonar QuadraBeam SonarWhat’s On the Display Bait BallHard Bottom Soft BottomViews Sonar ViewUnderstanding Sonar History Sonar ViewReal Time Sonar RTS Window Sonar Zoom ViewFull range view Sonar Zoom View200/83 kHz Split Sonar View Big Digits ViewDualBeam Plus and QuadraBeamTM Only 200/83 kHz Split Sonar ViewSide Beam View Bottom PresentationQuadraBeamTM Only Digital readouts in the Side Beam View cannot be customizedView Key POWER/LIGHT KeyKey Functions Exit Key Menu KeyWAY Cursor Control Key Menu System Accessory BusPowering Up the Unit Start-Up Options Menu Normal OperationSimulator System StatusPC Connect With PC Connect Cable OnlyTo adjust the Sensitivity To adjust the Upper RangeSonar X-PressTMMenu SensitivityBottom View Chart SpeedLower Range To adjust the Zoom Level Zoom LevelSonar Menu Tab Sonar Zoom View OnlyBeam Select Fish ID+TMTo use Beam Select Highlight Beam Select on the Sonar main menuKHz Balance Fish SensitivityKHz Sensitivity To change the Depth Lines setting To change the Surface Clutter settingDepth Lines Surface ClutterNoise Filter Max DepthWater Type Transducer SelectAlarms Menu Tab Depth AlarmFish ID Alarm Low Battery AlarmSetup Menu Tab Units DepthUnits Temp Units DistanceUser Mode Triplog ResetRestore Defaults Units SpeedSelect Views Select ReadoutsTo change the Depth Offset setting To change the Temp Offset settingDepth Offset Temp OffsetNmea Output Accessories Menu TabSpeed Calibration Troubleshooting Display ProblemsProblem Possible Cause Control head loses power at high speedsIsolation Matrix Fishing System AccessoriesFinding the Cause of Noise Specifications Contact Humminbird