3.Place your fingers in the slots the hinges came out of on either side of the unit and pull the filter out. Figure 7.
Figure 7.
4.Install the filter into the unit, using the arrows on the
side of the filter, indicating the air flow direction of the filter (Carbon side out).
Hinge Guide
Bumps
Figure 8.
5.Align the bumps on the hinges on the wire base with the holes on the bottom of the unit. Ensure the hinge guide is facing inward of the holes the hinges rest in and snap into place. Make sure once seated that the bumps on the hinges are seated securely in the holes on the bottom of the SOLO2. Figure 8.
6.Set your SOLO2 upright again and connect the power.
7.If the filter light on the front of the unit continues to blink, press the filter reset button on the back of the unit for 3 seconds to reset. Figure 2.
Troubleshooting
1.I am unable to control the SOLO2 with the provided software.
First ensure the power adapter is plugged in to a wall outlet and try controlling the SOLO2 from the touch controls on the front of the unit. If the unit works properly in this manner, shut down the SOLO2 from the controls on the unit, unplug the USB cable from the computer, and restart your computer. Once your computer has rebooted, reinsert the USB cable and launch the software. If this does not correct the problem, try reinstalling the software.
2.I cannot operate SOLO2 from the controls on the product.
Unplug the power adapter from the wall and allow it to set for one minute. Plug the power adapter back into the wall and press the up and down arrows on the front of the unit at the same time to turn it on.
3.How do I clean the SOLO2 unit?
Please refer to the cleaning instructions on page 6 of your owner’s manual.
4.Where can I purchase filters?
There is a link to the web where filters may be ordered under the filter button on SOLO2’s software interface, or you may contact Hunter directly at 1 (800)
©2008 Hunter Fan Co. | 7 | |
|
