Assembly of Humidifier Parts
ATTENTION: Before operating the unit, remove the tape strips located on the bottom of the power pack. These tape strips are used to secure the pump components during shipment and should be removed prior to operation. See Figure 1.
Tape
Figure 1
1.Remove the Care Free® Ultra Evaporative Humidifier from its packaging.
2.Select a location for your humidifier. The location should be flat, hard,
HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE DUE TO WATER SPILLAGE.
3.Remove the Lower Reservoir (marked with the number 2) from the Water Tank and Upper Reservoir (marked with the number 1). See Figure 2.
Water
Tank
Tank
CapPower
Pack
Upper
Reservoir
Lower
Reservoir
Figure 2
4.Set the Lower Reservoir on the flat, hard surface you have chosen.
NOTE: Once the unit has been filled with water and is operating, you should not use the Upper Reservoir handles or Water Tank handles to pick up and relocate the humidifier without emptying all water from the humidifier. Prior to moving
the humidifier, check the water window in the Lower Reservoir for water. If there is water in the Lower reservoir, remove the Water Tank and Upper Reservoir and drain all water.
Water
LowerTank
Reservoir
|
| Upper |
Water |
| Reservoir |
|
| |
|
| |
Tank |
| Tab |
Upper |
| Lower |
Reservoir |
| |
| Reservoir | |
|
|
Figure 3
5.Lift the Upper Reservoir (marked with the number 1) and Water Tank and place them on top of the Lower Reservoir (marked with the number 2) so that the two tabs in the Lower Reservoir snap into the Upper Reservoir. See Figure 3.
6.Take the Water Tank to a sink or tub to fill with water.
7.Unscrew the Tank Cap by twisting it counterclockwise and fill the Water Tank with cool water. NEVER USE HOT WATER. See Figure 4.
Tank Cap
Water
Tank
Figure 4
8.Replace the Tank Cap by screwing it back onto the Water Tank clockwise. Securely tighten the Tank Cap and make sure it is properly sealed. See Figure 5.
Tank Cap
Water
Tank
Figure 5
©2008 Hunter Fan Co. | 3 | 41785 Rev |
