4.Remove the Pump Cap from the Funnel Pump by holding the Pump Cap securely in one hand while twisting the Funnel Pump in a clockwise direction. This will unlock the two components. See Figures 14a and 14b.
Pump Cap
Funnel
Pump
Figure 14a
Power Pack
Fan Blade
Underside
Pump Cap
Tabs
Funnel Pump
Figure 14b
5.Remove the Atomizer and the Upper Reservoir. See Figure 15.
Atomizer
Upper Reservoir
Figure 15
6.Soak the Upper Reservoir, Funnel Pump, Pump Cap, and
Atomizer in a solution of one (1) gallon of water and eight
(8) ounces of vinegar for 30 minutes.
6.Soak the Upper Reservoir, Funnel Pump, Pump Cap, and
Atomizer in a solution of one (1) gallon of water and eight (8) ounces of vinegar for 30 minutes.
NOTE: If the Atomizer is covered with hard white scale, you may want to run this component through the dishwasher to loosen the scale before soaking.
The Atomizer is the only
7.To clean the Water Tank, fill the tank with one (1) gallon of water and eight (8) ounces of vinegar. Replace the Tank Cap tightly and shake the Water Tank vigorously until all interior surfaces have been exposed to the solution.
8.Rinse the Water Tank several times with cool, clean water.
9.After soaking, rinse the components with clean water several times. Use a soft cloth or sponge to remove any
10.To clean the surfaces of the Power Pack, wipe with a dry, soft cloth.
Reassembly of Humidifier Parts
1.Set the Lower Reservoir on the flat, hard surface you have chosen.
2.Attach the Upper Reservoir to the Lower Reservoir by engaging the two tabs on the sides. See Figure 16.
Water Tank
Tank Cap
Power Pack
Atomizer
Upper Res- ervoir
Tab
Lower
Reservoir
Figure 16
©2008 Hunter Fan Co. | 6 | 41785 Rev |