You can assemble your fan for standard mounting (steps 4-1 – 4-3) or for low profile mounting (steps 4-4 – 4-6).
4-1. If your ceiling is 9’ or higher, remove the 3” downrod pipe from the black ball. Remove the screw and push the pipe up through the ball. Remove the cross bar. read the cross bar through the longer (6”) pipe and insert the pipe into the black ball. Tighten the screw completely.
4-2. Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball.
4-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to Step 4-7.
CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.
4-4. Remove the set screw from the adapter.
Note: For low profile mounting, the downrod is replaced with the low profile washer. See Steps 4-4 – 4-6.
4-5. Place the low profile washer (lip up) into the canopy. Be sure the green ground wire is pointing up toward the ceiling.
4-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three locking screws.
4-7. Raise the fan and place the hook on the ceiling plate through the U-shaped hole in the rim.
WARNING: Fan may fall if not assembled as directed in these installation instructions.
Step 4-7
U-shaped
Hole
Locking
Screw 
Downrod
Canopy
Trim Ring