Hunter Fan 42406-01 installation manual Step Title, Installing the Ceiling Plate, Step Steps

	Step Title
	CAUTION: To avoid possible electrical shock, before installing your fan,
	disconnect the power by turning off the circuit breakers to the outlet box
	and associated wall switch location. If you cannot lock the circuit breakers
	in the off position, securely fasten a prominent warning device, such as a
	tag, to the service panel.
	2-1. Drill two pilot holes into the wood support structure through the
	outermost holes in the outlet box. The pilot holes should be 9/64”
	in diameter.
	2-2. Your fan comes with two neoprene noise isolators (“Isolators”).
	Position the isolators between the ceiling plate and ceiling by
	inserting the raised areas on each isolator into the holes in the
	ceiling plate.
	2-3. Thread the lead wires from the outlet box down through the hole
	in the middle of the ceiling plate.
	2-4. Align the slotted holes in the ceiling plate with the pilot holes you
	drilled in the wood support structure. For proper alignment use
5
	slotted holes directly across from each other.
	Note: The isolators should be flush against the ceiling.
	2-5. Place a flat washer on each of the two 3” wood screws and pass
	the screws through the slotted holes in the ceiling plate into the
	pilot holes you drilled.
	Tighten the screws into the 9/64” pilot holes; do not use lubricants
	on the screws. Do not over tighten.
		Flat Washer
		3” Wood Screw

2 • Installing the Ceiling Plate

Isolator

Ceiling

Plate

Step 2-2

Steps 2-3 – 2-5

Towards

Ceiling Peak

For Angled Ceilings: Be sure to orient the ceiling plate so that the two tabs are pointing towards the ceiling peak.

Hunter Fan Company 42406-01 • 20080926