WARNING: Fan may fall if not assembled as directed in these installation instructions.
You can assemble your fan for standard or angle mounting as shown in steps 3-1 – 3-4. For low profile mounting (ceilings less than 8 feet high), go to steps 3-5 – 3-11 on the next page.
For Standard or Angled Mounting:
3-1. Unbundle the wires from the fan.
3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod.
3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers.
CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.
3-4. Raise the fan and place the hook on the downrod through the loop on the ceiling plate. e arrows on the downrod and on the ceiling plate should both be pointing towards the tab hole on the canopy. Go to 4 • Wiring the Fan.
Downrod
Canopy