Hunter Fan 42616-01 Assembling the Fan, For Standard or Angle mounting, For Low Profile mounting

3 • Assembling the Fan

Standard or Angle Mounting

Steps 3-2 – 3-3

Downrod

Canopy

Canopy

Trim Ring

Set Screw

6

	Low Profile Mounting
Steps 3-5 – 3-6		Locking Screws
		Low Profile
Green		Washer
Ground
Wire
Canopy
Trim Ring		Canopy

Locking Screw

WARNING: Fan may fall if not assembled as directed in these installation instructions.

3-1. Unbundle the wires from the fan.

For Standard or Angle mounting:

3-2. Insert the downrod through the canopy and canopy trim ring. Feed the wires from the fan through the downrod on one side of the pin in the ball.

3-3. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers.

CAUTION: e adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.

For Low Profile mounting:

Note: For low profile mounting, the downrod is replaced with the low profile washer.

3-4. Remove the set screw from the adapter.

3-5. Place the low profile washer into the canopy with the lip down.

3-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three locking screws.

Step 3-6 (Detail) Adapter

Locking Screws

Low Profile

Washer

Hunter Fan Company 42616-01 • 02/20/06

42616-01 rev 02-14-06.indd 6 2/20/2006, 3:16 PM