Hunter Fan 42616-01 warranty Setting the Remote Transmitter and Receiver, Setting Dipswitches

4 • Setting the Remote Transmitter and Receiver

Setting Dipswitches

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.

e dipswitches for the receiver are located on the flat surface of the receiver. e dipswitches for the transmitter are in the the battery compartment.

Receiver Dipswitches

4-1. IMPORTANT! Before you change the dipswitch settings, make sure the battery is not connected to the transmitter.

Change the position of the dipswitches in the remote transmitter and the receiver. Make sure that the dipswitches match in

the remote receiver and transmitter. If they don’t match, the transmitter will not function.

4-2. Install the included 9-volt battery into the transmitter.

CAUTION: e remote control device complies with part 15 of the FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment.

Operation is subject to the following two conditions:

1.is device may not cause harmful interference.

2.is device must accept any interference received, including interference that may cause undesired operation.

WARNING: Use only the Hunter Fan speed control supplied with this fan.

4-3. Raise the fan and align the slots in the canopy with the hooks on the ceiling plate.

Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks.

Transmitter Dipswitches

Example Dipswitch Settings		7
Receiver 1	Receiver 2
������������	������������
������������	������������
Transmitter 1	Transmitter 2
������������	������������
������������	������������

42616-01 • 02/20/06 Hunter Fan Company

42616-01 rev 02-14-06.indd 7 2/20/2006, 3:16 PM