Hunter Fan 42700 warranty Setting the Remote Transmitter and Receiver

6 • Setting the Remote Transmitter and Receiver

IMPORTANT! Before you change the jumper settings, make sure the battery is not connected to the transmitter.

Setting Transmitter and Receiver Codes

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.

The jumpers for the receiver are located on the flat surface of the receiver. The jumpers for the transmitter are in the battery compartment. The jumpers are very small; you can move them most

Receiver Jumpers

Example Jumpers Settings

easily using a small pair of pliers or tweezers.

6-1. Change the position of the jumpers in the remote transmitter and the receiver. Make sure that the jumpers match in the remote receiver and transmitter. If they don’t match, the transmitter will not function.

6-2. Install the included 12-volt battery into the transmitter.

CAUTION: The remote control device complies with part 15 of the FCC rules. Changes or modifications not expressly approved by Hunter Fan Company could void your authority to operate this equipment.

Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Use only the Hunter Fan speed control supplied with this fan.

Receiver 1

4 3 2 1

Transmitter 1

4 3 2 1

4 = off

3 = on

2 = on

1 = on

Receiver 2

4 3 2 1

Transmitter 2

4 3 2 1

4 = off

3 = on

2 = off

1 = on

9

42700-01 • 01/15/08 • Hunter Fan Company