Hunter Fan 42737-01 manual Assembling and Hanging the Fan, Wiring the Fan, Single Switch Wiring

3 • Assembling and Hanging the Fan

Steps 3-1 – 3-2				You can assemble your fan for standard mounting (steps 3-1 – 3-2)
				or for low profile mounting (steps 3-3 – 3-4). Note: For low profile
	Downrod			mounting, the downrod is replaced with the low profile washer.
				3-1. To assemble fan to hang down from a flat or angled ceiling, insert
			Canopy	the downrod through the canopy and canopy trim ring. Feed the
				wires from the fan through the downrod.
		Canopy		3-2. Loosen the allen head set screw on the adapter using the large
				allen wrench. Screw the pipe and ball assembly into the fan
		Trim Ring		assembly. Note: When the pipe and ball assembly is fully installed,
		Set Screw
				2-3 threads on the pipe will still be visible; this is normal. Securely
				retighten the set screw with a wrench or pliers. Skip to Step 3-5.

	Steps 3-3 – 3-4		CAUTION: The adapter has a special coating on the threads. Do
			not remove this coating; the coating prevents the downrod from
		Low Profile Washer
			unscrewing. Once assembled, do not remove the downrod.
			3-3. Place the low profile washer (lip up) into the canopy. Be sure the
6			green ground wire is pointing up toward the ceiling.
			3-4. Align the holes in the washer with the holes in the adapter.
			Assemble securely with three #8-32 x 3/4” screws.
			3-5. Raise the fan and place the hook on the ceiling plate through the
			U-shaped hole in the rim.
			WARNING: Fan may fall if not assembled as directed in these
			installation instructions.
			Step 3-5
		#8-32 x 3/4” Screw	U-shaped
			Hole

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes.

4-1. Make sure the power to the outlet box and associated wall switch location is still OFF.

4-2. To connect the wires, hold the bare metal leads together and place a wire nut over them, then twist the wire nut clockwise until tight.

4-3. Connect the bare or green ground wired (grounded) from the ceiling to the green ground wire (grounded) from the ceiling plate and the green ground wire from the fan.

4-4. Connect the white wire (ungrounded) from the ceiling to the white wired (ungrounded) from the fan.

4-5. Connect the remaining wires as follows:

Single Switch Wiring:

•The black wire from the ceiling to the black and the black/ white wire from the fan.

Dual Switch Wiring:

•The black wire from the ceiling to the black wire from the fan.

•The black/white wire from the fan to the wire for the wall switch.

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

4-6Turn the splices upward and push them carefully back through the ceiling plate into the outlet box.

4-7 Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.

4 • Wiring the Fan

Step 4-3

7

Step 4-4

Wire Nut

Hunter Fan Company 42737-01 • 11/14/06 42737-01 • 11/14/06 Hunter Fan Company