Hunter Fan 42737-01 manual Note Glass shade style may vary

7 • Completing Your Installation With or Without a Light Fixture

Steps 7-1 – 7-3

Housing

Assembly Upper

Screw Switch

Housing

10

Your Hunter fan comes with an integrated light fixture assembly and an optional switch housing cap and plug button. This feature gives you the option of installing the fan with OR without the included light fixture.

The steps below direct you whether or not you are installing a light fixture.

WARNING: Use only the light fixture supplied with this fan model.

7-1. To attach the upper switch housing, partially install two #6-32 x 3/8” housing assembly screws into the switch housing mounting plate.

7-2. Feed the upper plug connector through the center opening of the housing.

7-3. Align the keyhole slots in the housing with the housing assembly screws.

7-4. Turn the housing counterclockwise until the housing assembly screws are firmly situated in the narrow end of the keyhole slots. Install the remaining #6-32 x 3/8” screw into the housing. Tighten all three screws firmly.

CAUTION: Make sure the upper switch housing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three assembly screws could result in the switch housing and light fixture falling.

7-6. To attach the lower switch housing, connect the upper plug connector from the motor to the lower plug connector in the lower switch housing assembly.

Note: Both plug connectors are polarized and will only fit together one way. Make sure the connectors are properly aligned before connecting them. Incorrect connection could cause improper operation and damage to the product.

7-7. Place the lower switch housing assembly over the upper switch housing. Align the side screw holes in the upper and lower switch housings. Attach the lower switch housing to the upper switch housing

7-8. To install each shade, first loosen the three thumbscrews.

7-9. Raise the shade to the light fixture. Tighten the thumbscrews securely.

7-10.Install four B10 candelabra light bulbs (60 Watt maximum each).

Note: Glass shade style may vary.

Plug

Connector

Steps 7-5 – 7-6

Lower Switch

Housing

Plug

Connector

Detail

11

Housing

Assembly Screw

Thumbscrews

Shade

Bulb

Step 7-4

Hunter Fan Company 42737-01 • 11/14/06

Steps 7-7 – 7-9

42737-01 • 11/14/06 Hunter Fan Company