Hunter Fan 42786-01 Attaching The Switch Housing Gasket, And Upper Switch Housing

7 • Completing Your Installation With a Bowl Light Fixture

Your Hunter fan comes with an integrated light fixture assembly.

WARNING: Use only the light fixture supplied with this fan model.

The switch housing assembly is made up of three sections: the switch housing gasket, the upper switch housing, and the lower switch housing/ light assembly.

ATTACHING THE SWITCH HOUSING GASKET

AND UPPER SWITCH HOUSING

7-1. Locate the switch housing mounting plate, the switch housing gasket and the upper plug connector as shown.

NOTE: Your fan may come with the switch housing gasket attached to the switch housing mounting plate.

If the switch housing gasket is attached to the switch housing mount- ing plate, go to the section "Attaching the Upper Switch Housing."

If the switch housing gasket is not attached complete the steps below.

7-2. Identify the top side of the switch housing gasket by looking for the raised circular ridge on the gasket.

7-3. With the top side of the switch housing gasket facing up towards the motor, align the holes in the gasket with the spokes on the switch housing mounting plate.

7-4. Feed the upper plug connector through the center opening of the upper switch housing. Push the gasket up so that it is seated flush with the mounting plate .

CAUTION: Make sure the upper switch housing is securely attached to the switch housing mounting plate. Failure to properly attach and tighten all three assembly screws could result in the switch housing and light fixture falling.

Gasket

Step 7-1

Holes

Step 7-3

Upper

Switch

Housing

Step 7-4

Mounting

Plate

Upper

Plug

Spokes

Upper

Plug

10

42786-01 • 08/14/09 • Hunter Fan Company