Hunter Fan 83001 manual D11, D12, D13 D14, D15, Existing Construction accessible only from below

Existing Construction – accessible only from below

D11 EXISTING FAN

D12

F

Remove an existing fan and check to make sure the open-	Move the housing into position above the ceiling
ing is large enough to accommodate the new motor hous-
ing (9”x 9.75”).

D13	D14
	2
	1

Route wires through strain relief. For supply connection,

use wires suitable for at least 90º C (194º F).

Attach existing ducting to duct connector. Tape joints.

If ducting does not fit securely,

an adapter may need to be purchased.

D15

F

Install the housing flush with the sheetrock and secure by

tightening the pre-loaded screws into the joist.

41949-01 3/29/2006

05-HF-011-EngS_3.29.06.indd 15

15

3/29/06 8:58:21 AM