12 42733-01 04/26/2007
ENGLISH
This fan is permanently lubricated
and will not require additional lubri-
cation (oil) for the life of the fan.
This fan requires little maintenance
and contains no user serviceable
parts. do NoT try to x it yourself.
Contact qualied service personnel if
servicing is needed.
To CLEaN:
1. Before cleaning, turn the fan
o and remove the plug from
electrical outlet. wipe o excess
dust with a lint-free cloth.
2. do NoT immerse the fan in wa-
ter or any other liquid.
CLEaNING GrILLE aNd BLadES
1. Turn the fan o and remove the
plug from the electrical outlet.
2. To disassemble the Grille, un-
latch the Grille ring Latch,
remove the Grille ring and the
Interlock Bracket.
3. Loosen the Blade assembly
Setscrew and slide the Blade as-
sembly o of the Motor Shaft.
4. The Grilles and the Blade assem-
bly may be cleaned with mild
soap and water.
5. use a soft, slightly damp cloth
to wipe the remaining fan parts.
6. when the Blade assembly and
Grilles have dried completely,
reassemble the fan following
assembly steps 18 - 27 of this
manual.
7. do NoT plug fan into an elec-
trical outlet until it has been
fully reassembled.
5. To adjust the upward or down-
ward ow of air, loosen the an-
gle adjustment knob beneath
the Fan Motor. See Figure 13.
position the fan to the desired
angle, and tighten the angle
adjust knob.
6. To make the fan oscillate, push
the oscillation pin down. To
stop the fan from oscillating,
pull the oscillation pin up. See
Figure 13.
7. To adjust the height of your
fan, hold the Telescoping pole
securely with one hand, and
twist the Height adjustment
Grip counterclockwise. while
supporting the fan motor, raise
or lower the Telescoping pole to
the desired height, then tighten
the Height adjustment Grip.
MaINTENaNCE