Hunter Fan Type 3 Models, 45007 warranty Wiring the Fan, wiring, use a qualified electrician

Antenna

Receiver

5 • Wiring the Fan

	All wiring must be in accordance with national and local
	electrical codes and ANSI/NFPA 70. If you are unfamiliar with
	wiring, use a qualified electrician.
	5-1. Make sure the power is still off.
	5-2. Position the receiver in the canopy so that the antenna is close
		to the edge of the ceiling plate for clear reception.
Step 5-4	5-3. To connect the wires, hold the bare metal leads together
		and place a wire connector over them, then twist clockwise
		until tight. For all these connections use the wire connectors
		provided.
			CAUTION: Be sure no bare wire or wire strands are visible after
			making connections.
	5-4. Using a large wire connector, connect the ground wire from the
		ceiling to the green ground wire from the ceiling plate and the
Step 5-5		green ground wire from the downrod.
	5-5. Using the large wire connectors, connect the white wire and the
		black wire from the ceiling as follows:
			• The white (common) power wire from the ceiling to the white
			wire from the receiver (marked on red tag “NEUTRAL IN”)
			• The black power wire from the ceiling to the black wire from
			the receiver (marked on red tag “LIVE IN”)
	5-6. Using the small wire connectors, connect the wires from the fan
Step 5-6		as follows:
			• The black/white wire from the fan to the red wire from the
			receiver (marked on white tag “LIGHT OUT”)
			• The black wire from the fan to the black wire from the
			receiver (marked on white tag “FAN OUT”)
			• The white wire from the fan to the white wire from the
			receiver (marked on white tag “COMMON OUT”)
	5-7. Check each connection to make sure no bare wire or wire
		strands are visible. Push all wires and wire connectors, except
		for the white antenna wire from the receiver, back through the
		ceiling plate into the outlet box.
			8

45007-01 • 11/02/07 • Hunter Fan Company