Husky H1600 Wand is malfunctioning, Gun is not operating properly, With the wand pointing upwards

PROBLEM OR CONCERN	POSSIBLE CAUSE	SOLUTION
	Wand is malfunctioning	Test wand to ensure that it is not malfunctioning.
	Gun is not operating properly	Remove Wand from the Gun and squeeze trigger to
		ensure that the water is coming out of the front of the
		Gun at a rate equal to the Garden Hose.
Wand - Attaching		To attach the Wand apply some moderate
		downward pressure on the Wand (In the direction
		of the trigger) while simultaneously twisting the
		wand a 1/4 of a turn counterclockwise. (It may
		help if you set the gun vertically on a flat surface
		with the wand pointing upwards).
		The two tabs on the end of the Wand must slide
		all the way in before the Wand will twist and
		lock.
		If this does not work remove the o-ring from
		the end of the wand and attach it without the
		o-ring. If the wand attaches, you will need to
		replace the o-ring.
		Contact us at:
		customerservice@huskypowerwasher.com
		or order a replacement directly online at:
		www.huskypowerwasher.com.
Wand - Removing		Release the back pressure in the Gun/Hose.
		Remove the Garden Hose from the unit and
		squeeze the trigger of the Gun.
		Apply some moderate downward pressure on
		the Wand (In the direction of the trigger) while
		simultaneously twisting the wand a 1/4 of a turn
		clockwise. (It may help if you set the gun vertically
		on a flat surface with the Wand pointing upwards).
		For additional assistance you can email us at:
		customerservice@huskypowerwasher.com.

23