OPERATION
MOVING THE PRESSURE WASHER
See Figure 14.
NOTE: Never lift or carry this product using the moving handle.
Turn the pressure washer off.
Standing at the back of the machine, grasp the handle firmly with both hands and pull the handle up until it locks into place with a “click”.
Tilt the machine toward you until it balances on the wheels, then roll the machine to the desired position.
STORING THE PRESSURE WASHER
See Figure 14.
�����Store the pressure washer with the gas tank empty by either draining the tank or running the pressure washer until the
gas runs out. Allow 30 minutes of “cool down” time before storing the machine. Store in a dry, covered area where the weather can’t damage it.
WASHING WITH DETERGENT
See Figure 15.
TO MOVE THE MACHINE
TO STORE THE MACHINE
Use only detergents designed for pressure washers; house- hold detergents can damage the pump. Many detergents require mixing prior to use. Prepare cleaning solution as instructed on the solution bottle; test a small area first to avoid surface damage.
Place the injection hose in the bottom of the detergent bottle / container.
Install the black nozzle on the spray wand.
Spray the detergent on a dry surface using long, even, overlapping strokes. To prevent streaking, do not allow detergent to dry on the surface.
Before shutting off the engine:
Place the injection hose in a bucket of clean water.
Flush for 1 - 2 minutes (spray clear water through the spray wand).
Shut off the engine.
NOTE: Shutting OFF ( O ) the engine will not relieve pressure 
in the system. Pull trigger to release water pressure. 
RINSING WITH THE PRESSURE WASHER
�Turn off the pressure washer and shut off the water supply. Pull trigger to release water pressure.
Engage the lock out on the wand by pushing up on the lock out until it clicks into the slot.
Pull back and hold the collar.
Remove the nozzle by pulling it from the collar.
Select the right nozzle for the job:
•Use lower pressure nozzle (green) to wash items such as a car or boat.
•Use higher pressure nozzle (red) for jobs such as strip- ping paint and degreasing the driveway. When using these nozzles, test a small area first to avoid surface damage.
Start at the top of the area to be rinsed and work down, overlapping the strokes.
DETERGENT 
CONTAINER
INJECTION
HOSE
Fig. 14
Fig. 15
15
