USING THE BLOWER
To vacuum debris from the ground (225BX-SERIES)
The vacuuming device is an accessory and is not included in the standard supply.
Fitting the collection bag with the various vacuum tubes
!WARNING!
When fitting the tubes to the blower, the engine must be switched off and the stop switch must be in the stop position.
1.Open the collection bag. Insert the collection bag tube from inside the bag to fit in the vacuum inlet opening of the bag as illustrated in the adjacent figure. Close the zipper on the bag.
2.Press the collection bag tube on the blower, turn it 1/4 of a turn until a snap is heard. The section of the tube that is covered by the collection bag must arranged with its outlet pointing downwards. Attach the carrying strap to the harness ring.
3.Open the cover at the underside of the blower, using a screw driver to disengage the locking piece in the square opening.
4.Press the vacuum tube in the large opening at the underside of the blower and turn it 45 degrees until the bayonet mount locks.
5.Push the lower vacuum tube onto the upper tube as shown in the adjacent figure.
6.Fit the auxiliary handle as described in the separate instructions.
Vacuuming
Before vacuuming, put on the required safety equip- ment.
!WARNING!
When working with the blower, wear the required protecting equipment.
1.Hearing protection.
2.Eye protection.
3.Face mask in dusty environments.
25 |
22 |
23 |
24 |
18 – English
