SERVICE AND
TO LEVEL MOWER
Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.
VISUAL
•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower iscutting lower.
NOTE: As desired, you can raise the low side of mower or lower the high side.
•Go to side of mower you wish to adjust.
•With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower the mower, or, to the right to raise the mower.
Turn nut right | Turn nut left |
to raise mower | to lower mower |
Fig. 36
NOTE: Each full turn of adjustment nut will change mower height about 3/16".
•Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.
PRECISION
•With all tires properly inflated, park tractor on level ground or driveway.
your hands with gloves and/or wrap
i_CAUTION: Blades are sharp. Protect blade with heavy cloth.
eRaise mower to its highest position.
eAt both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.
Fig. 37
ADJUSTMENTS
•If adjustment is necessary, see steps in Visual Adjust- ment instructions above.
•Recheck measurements, adjust if necessary until both sides are equal.
To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.
your hands with gloves and/or wrap
_ CAUTION: Blades are sharp. Protect blade with heavy cloth.
eRaise mower to highest position.
ePosition any blade so the tip is pointing straightforward. Measure distance (B) to the ground at front and rear tip of the blade.
Fig. 37
If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.
With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.
With a 3/4" or adjustable wrench, turn front link adjust- ment nut (B)clockwise (tighten) to raise the front of mow- er,or, counterclockwise (loosen) to lower the front mower.
TIGHTEN | ADJUST | LOOSEN |
NUT B TO | RAISE | ADJUST NUT |
MOWER | .... / | B TO LOWER |
|
| MOWER |
LOOSEN JAM NUTA | FIRST | |
Fig. 39
NOTE: Each full turn of the adjustment nut will change mower height about 1/8".
•Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.
•Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.
22
