Assembly, Assembling the loop handlebar

ASSEMBLY

• Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.

•Fit the bolt, securing plate and wing nut as shown in the diagram.

•Tighten the wing nut.

• Assemble the angle gear back on the supporting tube. Turn the blade so that the drive shaft engages in the angle gear.

• Position the angle gear so that its slot is aligned with the line on the supporting tube.

• Firmly tighten the screw.

Fit the blade as follows:

1. Fit the drive disc (A) on the outgoing shaft. Make sure that the edge that ﬁts in the hole of the blade is facing outward.

2. Block the blade rotation by inserting locking pin in the hole behind the blade guard engaging it in the corresponding hole in the drive disc.

3.Fit the blade (B) on the drive disc.

4.Fit the support

ﬂange (C). The support ﬂange must be ﬁtted with its outer edge hard up against the blade.

5. Fit the locknut (D). NOTE! The locknut has left-hand threads. The tightening torque of the locknut is 35

– 50 Nm.

6. Remove the locking pin.

NOTE! Do not forget to remove the locking pin before using the machine.

!WARNING!

Under no circumstances may the edge cutter blade be used without the blade guard ﬁtted.

English – 13