ASSEMBLY
Fitting the loop handle
(326C)
•Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.
•Fit the screw, securing plate and wing nut as shown in the diagram.
•Tighten the wing nut.
Fitting the loop handle
(326L, 326Lx, 326LDx)
•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.
•Slide the spacer into the slot in the loop handle.
•326L: Fit the nut, washer and screw.
326LX/326LDX: Fit the nut, knob and screw. Do not overtighten.
•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.
Assembling and dismantling the two-piece shaft
(326LDx)
Assembly:
•Make sure the knob is loose.
•Align the
•Tighten the knob.
Dismantling:
•Undo the knob (at least three turns).
•Push the knob towards the coupling.
•Carefully twist the lower half of the shaft to unlock it.
•Hold both parts of the shaft and pull the lower part of the shaft out of the coupling.
10 – English