Husqvarna 327LD, 327LS manual Contents, Note the following before starting

CONTENTS

Contents
KEY TO SYMBOLS
Symbols	2
CONTENTS
Contents	3
Note the following before starting:	3
INTRODUCTION
Dear customer!	4
WHAT IS WHAT?
What is what?	5
GENERAL SAFETY PRECAUTIONS
Important	6
Personal protective equipment	6
Machine′s safety equipment	7
Cutting equipment	9
ASSEMBLY
Fitting the loop handle	11
Assembling and dismantling the two-piece shaft
(327LDx)	11
Assembling the cutting equipment	12
Fitting the trimmer guard and trimmer head	12
FUEL HANDLING
Fuel safety	13
Fuel	13
Fueling	14
STARTING AND STOPPING
Check before starting	15
Starting and stopping	15
WORKING TECHNIQUES
General working instructions	17
MAINTENANCE
Carburetor	19
Muffler	19
Cooling system	20
Spark plug	20
Two-piece shaft (327LDx)	21
Air filter	21
Maintenance schedule	23
TECHNICAL DATA
Technical data	24
FEDERAL AND CALIFORNIA EMISSIONS
CONTROL WARRANTY STATEMENT
YOUR WARRANTY RIGHTS AND OBLIGATIONS	26

Note the following before starting:

Please read the operator’s manual carefully.

Maintenance, replacement, or repair of the emission control devices and system may be performed by any nonroad engine repair establishment or individual.

WARNING! Long-term exposure to noise

! can result in permanent hearing impairment. So always use approved hearing protection.

WARNING! Under no circumstances may

! the design of the machine be modified without the permission of the manufacturer. Always use genuine accessories. Non-authorized modifications and/or accessories can result in serious personal injury or the death of the operator or others.

Your warranty may not cover damage or liability caused by the use of non- authorized accessories or replacement parts.

WARNING! A clearing saw, brushcutter

! or trimmer can be dangerous if used incorrectly or carelessly, and can cause serious or fatal injury to the operator or others. It is extremely important that you read and understand the contents of this operator’s manual.

The Emissions Compliance Period referred to on the Emission Compliance label indicates the number of operating hours for which the engine has been shown to meet Federal and Californian emissions requirements.

English – 3