Husqvarna 327LD, 327LS manual Assembly, Fitting the loop handle, Dismantling

ASSEMBLY

Fitting the loop handle

•Clip the loop handle onto the shaft. Note that the loop handle must be fitted between the arrows on the shaft.

•Slide the spacer into the slot in the loop handle. Fit the nut, knob and screw. Do not overtighten.

•Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.

Assembling and dismantling the two-piece shaft (327LDx)

Assembly:

•Loosen the coupling by turning the knob.

•Align the tab of the attachment (A) with the arrow on the coupling (B).

B

A

•Push the attachment into the coupling until the attachment snaps into place.

•Before using the unit, tighten the knob securely.

Dismantling:

•Loosen the coupling by turning the knob (at least 3 times).

•Push and hold the button (C). While securely holding the engine end, pull the attachment straight out of the coupling.

C

English – 11