GENERAL SAFETY PRECAUTIONS
12 – English
Cutting equipment designed to reduce
kickback
The only way to avoid kickback is to make sure that the
kickback zone of the bar never touches anything.
By using cutting equipment with ”built-in” kic kback reduction
and keeping the chain sharp and well-maintained you can
reduce the effects of kickback.
Bar
The smaller the tip radius the lower the chance of kickback.
Chain
A chain is made up of a number of links , which are av ailab le
in standard and low-kickback versions.
Some terms that describe the bar and chain
To maintain the saf ety features of the cutting equipment, y ou
should replace a worn or damaged bar or chain with a bar
and chain combinations recommended by Husqvarna. See
instructions under the heading Technical Data for a list of
replacement bar and chain combinations we recommend.
Bar
• Length (inches/cm)
• Number of teeth on bar tip sprocket (T).
• Chain pitch (inches). The spacing betw een the drive links
of the chain must match the spacing of the teeth on the
bar tip sprocket and drive sprocket.
• Number of drive links. The number of drive links is
determined by the length of the bar, the chain pitch and
the number of teeth on the bar tip sprocket.
• Bar groove width (inches/mm). The groove in the bar
must match the width of the chain drive links.
• Chain oil hole and hole for chain tensioner. The bar must
be matched to the chain saw design.
Chain
• Chain pitch (inches)
• Drive link width (mm/inches)
• Number of drive links.
Sharpening y our chain and adjusting depth
gauge setting
General information on sharpening cutting teeth
• Never use a blunt chain. When the chain is blunt you
hav e to e x ert more pressure to force the bar through the
wood and the chips will be very small. If the chain is v ery
blunt it will produce wood powder and no chips or
shavings.
• A sharp chain eats its way through the wood and
produces long, thick chips or shavings.
!
WARNING! Faulty cutting equipment or the
wrong combination of bar and saw chain
increases the risk of kickbac k! Only use the
bar/saw chain combinations we
recommend, and follow the filing
instructions. See instructions under the
heading Technical data.
IMPORTANT! No saw chain design eliminates the danger
of kickback.
!
WARNING! Any contact with a rotating saw
chain can cause extremely serious injuries.