KD-80 (V-Kick Trigger)

7.Loosen the T-bolts for the stay and mount the legs on the stay.

Install the legs as shown in the figure so that the ends of

If you are using a kick pedal with an under plate

Adjust the length of the legs so that the four legs of the

the legs protrude by about 1 inch (2 cm).

KD-80 and the heel of the kick pedal contact the floor

 

 

evenly.

13. Adjust the striking point for the beater.

The beater's striking point is adjusted to fall at the center of the head.

Adjust the striking point so that it doesn't extend beyond the cushion on the back of the head.

 

When Using a Twin (Double Kick) Pedal

 

With the KD-80, you can also play using a twin (double kick)

 

pedal.

Extend the leg

Set this up so the striking points of the two beaters fall at equal

distances to the left and right of the center of the head.

by about 1 inch

(2 cm).

 

8. Tighten the T-bolts to secure the legs to the stand.

When using a twin (double kick) pedal, as with a regular

9. Lift the KD-80 and place the stand and the four legs

pedal, use the included beater or a plastic beater as the beater

upright.

for the kick pedal.

10. Adjust the angle of the stand plate so that it's at a right angle to the floor.

Loosen the T bolts that you tightened in step 8, and adjust the length of the legs so that the stand plate is vertical to the floor. Then firmly tighten the T bolts.

11.Install the included beater on your kick pedal.

12.Mount the kick pedal on the KD-80.

 

 

 

Specifications

Adjust

 

 

KD-80: V-Kick Trigger

the leg length

 

 

Pad Size: 8 inches

 

 

 

 

 

Under plate

Trigger: 1

Stand plate

 

 

Dimensions: 440 (W) x 340 (D) x 465 (H) mm

 

Heel portion

17-3/8 (W) x 13-7/16 (D) x 18-5/16 (H) inches

 

 

 

60°

90°

Weight: 4.8 kg

 

 

 

 

 

10 lbs 10 oz

Install the kick pedal securely.

Set the KD-80 so no mechanical noise is heard when you step on pedal.

Make sure that KD-80 does not touch the drum stand or the other pads.

9

Page 9
Image 9
Roland TD-8KV owner manual Specifications, Adjust the striking point for the beater, Upright