TECHNICAL DATA
| 395XP |
Engine |
|
Cylinder volume, cu.in/cm3 | 5,7/94 |
Cylinder bore, inch/mm | 2,2/56 |
Stroke, inch/mm | 1,5/38 |
Idle speed, rpm | 2 500 |
Recommended max. |
|
speed, unloaded, rpm | 12 500 |
Power, kW/rpm | 5,2/ 9 600 |
Ignition system |
|
Manufacture | SEM |
Type of ignition system | CD |
Spark plug | Champion |
Electrode gap, inch/mm | RCJ 7Y |
0,020"/0,5 | |
Fuel and lubrication |
|
system |
|
Manufacturer | Tillotson |
Carburetor type | HS 298 A |
Fuel capacity, US pint/litre | 1,9/0,9 |
Oil pump capacity at 8500 rpm, |
|
ml/min | |
Oil capacity, US pint/litre | 0,9/0,5 |
Type of oil pump | Automatic |
Weight |
|
Without bar and chain, Lbs/kg | 17,4/7,9 |
Chain/bar |
|
Standard bar length, inches/cm | 18"/45 |
Recommended bar lengths, |
|
inches/cm | |
Usable cutting length |
|
inches/cm | |
Chain speed at max. |
|
power, m/sec | 21,4 |
Pitch, inch/mm | 3/8" / 9,52 |
Thickness of drive link, | 0,404"/10,26 |
| |
inch/mm | 0,050"/1,3 |
| 0,058"/1,5 |
Number of teeth on drive | 0,063"/1,6 |
| |
sprocket | 7 |
Recommended original and replacement bar and chain combinations
This Husqvarna saw model is in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low kickback performance requirements. However, for the Husqvarna chain saw model 395XP we recommend the following cutting equipment.
| Guide bar |
| Saw chain |
Length | Pitch | Max nose |
|
inch | inch | radius |
|
3/8 | 11T | Husqvarna H42 / S48 or | |
3/8 | ATM 1,33" Oregon 73LP / 73LG | ||
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
The combinations of power head, bar and chain have been investigated in accordance with the vibration requirements of ANSI B
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar, see the table below.
0,050"/1,3mm | – | 72LP | 72LG |
|
|
|
|
0,058"/1,5mm | H42/73LP | S48/73LG | – |
|
|
|
|
0,063"/1,6 mm | – | 75LP | 75LG |
|
|
|
|
34´*2•=¶5Y¨
– English
