MAINTENANCE
recoil spring by letting the pulley rotate slowly backwards.
1 2
•Undo the bolt in the centre of the pulley and remove the drive disc (A), drive disc spring (B) and the pulley
(C). Insert and secure a new starter cord in the starter pulley. Wind approx. 3 turns of the starter cord on the starter pulley. Fit the starter pulley so that the end of the recoil spring (D) hooks into the starter pulley. Now assemble the drive disc spring, drive disc and the bolt in the centre of the pulley. Carry the starter cord through the hole in the starter housing and the starter handle. Tie a good knot on the starter cord.
Tensioning the recoil spring
•Hook the starter cord in the notch in the pulley and turn the starter pulley about 2 turns clockwise.
Note! Check that the pulley can be turned an additional 1/2 turn when the starter cord is pulled all the way out.
Stretch the line with the handle. Move your thumb and release the line. See the figure below.
Replacing the return and drive springs
Recoil spring (A)
•Lift up the starter pulley. See instructions under the heading Changing a broken or worn starter cord. Remember that the recoil spring is coiled under tension in the starter housing.
•Remove the cassette with the recoil spring from the starter.
•Lubricate the recoil spring with light oil. Fit the cassette with recoil spring in the starter. Fit the starter pulley and tension the recoil spring.
Drive disc spring (B)
•Undo the bolt in the centre of the pulley and remove the drive disc and the drive disc spring.
•Replace the drive disc spring and fit the drive disc above the spring.
A
B
34 – English
