MAINTENANCE
Checking the inertia brake release
With the engine turned off, hold the chain saw over a stump or other firm object. Let go of the front handle so that the bar drops towards the stump as the chain saw rotates around the rear handle.
When the bar hits the stump the brake should be applied.
Checking the
Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.
Push the trigger up and forwards to check that it moves freely and is securely hinged to the clutch cover.
Never carry or hang the saw by the trigger! This could damage the mechanism and disable the chain brake.
Checking the brake trigger
Place the chain saw on firm ground and start it. Make sure the chain does not touch the ground or any other object. See the instructions under the heading Start and stop.
Grasp the chain saw firmly, wrapping your fingers and thumbs around the handles.
Apply full throttle and activate the chain brake by tilting your left wrist forward onto the front hand guard. Do not let go of the front handle. The chain should stop immediately.
English – 31
