ASSEMBLY
Assembling the handlebar and throttle
Assembling the cutting equipment
•Remove the screw at the rear of the throttle handle.
•Slide the throttle handle onto the right side of the handlebar, (see diagram).
!
WARNING!
When fitting the cutting attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.
•Align the screw hole in the throttle handle with the hole in the handlebar.
•Refit the screw in the hole in the rear of the throttle handle.
•Screw the screw through the handle and handlebar. Tighten it.
RXT 
RX
•Fit the mounting components as shown.
•Loosely tighten the four screws. (R)
•Put on the harness and hang the machine from the support hook. Now make a final adjustment so that the machine is in a comfortable working position when it hangs from the harness.
•Tighten the knob.
! | WARNING! Never use a cutting | |
attachment without an approved guard. | ||
| ||
| See the chapter on Technical data. If an | |
| incorrect or faulty guard is fitted this can | |
| cause serious personal injury. |
IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.
Fitting the guard extension
CAUTION! The guard extension shall always be fitted when using the trimmer head/plastic blades and combination guard. The guard extension shall always be removed when using the grass blade and combination guard.
Enter the guard extension guide in the slot of the combination guard. Then click the guard extension into position on the guard with the four
English – 13
