Husqvarna 53S INTEK manual Environmental Information

Models: 53S INTEK

1 12
Download 12 pages 26.22 Kb
Page 9
Image 9

Maintenance

The engine brake cable should always be adjusted to stop the engine within 3 sec. CAUTION! For adjustment contact your authorized service dealer.

At the End of the Mowing Season

1.Replace blade, bolts, nuts or screws, if necessary.

2.Clean your lawnmower thoroughly.

3.Ask your local service dealer to clean the air filter thoroughly and carry out any service or repairs required.

4.Drain engine of oil and gasoline.

Storing your Lawnmower

1.Do not store your lawnmower immediately after use.

2.Wait until the engine has cooled to avoid a potential fire hazard.

3.Disconnect the spark plug lead.

4.Clean your lawnmower

5.Loosen handle adjusters (A2) on both sides of the product and fold the handle forward.(M)

6.Store in a cool, dry place where your lawnmower

is protected from damage.

Service Recommendations

Your product is uniquely identified by a silver and black product rating label.

We strongly recommend that your product is serviced at least every twelve months, more often in a professional application.

Engine Maintenance Schedule

Follow the hourly or calendar intervals, whichever occur first. More frequent service is required when operating in adverse conditions

First 5 hours - Change oil.

Every 5 hours or daily - Check oil lever. Clean finger guard. Clean around muffler.

Every 25 hours or every season - Change oil if operating under heavy load or high ambient temperature. Service air cleaner.

Every 50 hours or every season - Change oil. Inspect spark arrester, if equipped.

Every 100 hours or every season - Clean cooling system*. Replace spark plug.

*Clean more often under dusty conditions, or when airborne debris is present or after

prolonged operation cutting tall, dry grass.

Engine Servicing & Guarantee

The engine fitted to your lawnmower is guaranteed by the Engine Manufacturer. To obtain further information contact your dealer.

Trouble Shooting

Engine Will Not Start

1.Ensure OPC Lever is in the start position.

2.Check that the control lever is in the '+' position

3.Check that there is sufficient fuel in the tank and the cap air vent is clear.

4.Remove and dry the spark plug.

5.Gasoline may be stale, replace. Once gasoline has been replaced, it may take a little time for fresh gasoline to filter through.

6.Check that the blade bolt is tight. A loose bolt could cause difficult starting.

7.If the engine will still not start, immediately disconnect the spark plug lead.

8.CONSULT YOUR LOCAL APPROVED SERVICE DEALER.

Lack of Engine Power and/or Overheating

1.Check that the control lever is in the 'normal' position.

2.Disconnect the spark plug lead and allow the engine to cool down.

3.Clean grass clippings and debris from around the engine and air inlets and the underside of the deck including the chute.

4.Clean the engine air filter (Ask your local Approved Service Dealer to clean the engine air filter thoroughly).

5.Gasoline may be stale, replace. Once gasoline has been replaced, it may take a little time for fresh gasoline to filter through.

6.If the engine still lacks power and/or is overheating, Immediately disconnect the spark plug lead.

7.CONSULT YOUR LOCAL APPROVED SERVICE DEALER.

Excessive Vibration

1.Disconnect the spark plug lead.

2.Check that the blade is correctly fitted.

3.If the blade is damaged or worn replace it with a new one.

4.If vibration persists, immediately disconnect the spark plug lead.

5.CONSULT YOUR LOCAL APPROVED SERVICE DEALER.

Environmental Information

Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life.

Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.

Awareness of the environment must be considered when disposing of ‘end-of-life’ product.

If necessary, contact your local authority for disposal information.

DISPOSAL OF FUELS AND LUBRICATING OILS

Wear protective clothing when handling any fuels and lubricants.

Avoid contact with skin.

Remove gasoline and engine oil before transporting the product.

Contact your local authority for information of your nearest Recycling/Disposal Station.

Do NOT dispose of used fuels/oils with household waste

Waste fuels/oils are harmful, but can be recycled and should be disposed of through the recognised facilities.

Do NOT dispose of used fuels/oils to water.

Do NOT incinerate

8

Page 9
Image 9
Husqvarna 53S INTEK manual Environmental Information