GE PT925 manual Error Codes, Meaning, Cause/Correction

Error Codes

Access the ERC failure codes by pressing the UPPER START pad and the CLOCK pad for 3 seconds.

To clear the fault codes, press the UPPER COOK TIME pad and the UPPER DELAY START pad for 3 seconds. The oven may stop operating but not immediately give and F code on the display.

FAILURE	MEANING	CAUSE/CORRECTION
CODE
F0	Glass touch key pad failure	Replace glass touch key pad.
F2	Oven temperature inside oven cavity as measured by	• Check for bad signal using Service Mode.
	the sensor:	• Remove the ribbon cable from the upper
	Unlocked:
		door and measure resistance:
	>650° (2237 ohms)	• Upper = Pins 13/14; Lower = Pins 11/12
	Locked:	• If resistance is high, replace the oven sensor.
	>915°F (2724 ohms)
		• If resistance is okay, look for damaged
		harness terminals or replace the display/
		logic board.
F3	Open oven sensor (over 2850 ohms)	• Check for bad signal using Service Mode.
		• Remove the ribbon cable from the upper
		door and measure resistance:
		• Upper = Pins 13/14; Lower = Pins 11/12
		• If resistance is high, replace the oven sensor.
		• If resistance is okay, look for damaged
		harness terminals or replace the display/
		logic board.
F4	Shorted oven sensor (under 950 ohms)	• Check for bad signal using Service Mode.
		• Remove the ribbon cable from the upper
		door and measure resistance.
		• Upper = Pins 13/14; Lower = Pins 11/12
		• If resistance is low, replace the oven sensor.
		• If resistance is okay, look for damaged
		harness terminals or replace the display/
		logic board.
F5	Display/logic board failure	Replace the display/logic board.
F7	Shorted key	Determine if problem is with glass touch keypad
		or display/logic board by disconnecting keypad
		cable and power up control. If no F7 code,
		problem is with glass touch keypad.
F8	EEPROM failure	Replace the display/logic board.
F9	Sail switch error	Check the sail switch and cooling fan using
		Service Mode.
FC	Door lock error	Check the door lock motor using Service Mode.

– 57 –