GE PT925 manual Using the Clock, Kitchen Timer, and Control Lock, To Set the Clock

Using the Clock, Kitchen Timer, and Control Lock

To Set the Clock

The clock must be set to the correct time of day for the automatic oven timing functions to work properly. The time of day cannot be changed during a timed baking or self-cleaning cycle.

1.Touch the CLOCK pad.

2.Touch the number pads.

3.Touch the START pad.

_________________________________________________________________________________________

To Set the Kitchen Timer

1. Touch the TIMER pad.

2.Touch the number pads until the amount of time you want shows in the display. For example, to set 2 hours and 45 minutes, touch 2, 4 and 5 in that order. If you make a mistake, touch the TIMER pad and begin again.

3.Touch the START pad.

After touching the START pad, SET disappears; this tells you the time is counting down, although the display does not change until one minute has passed. Seconds will not be shown in the display until the last minute is counting down.

4.When the Kitchen Timer reaches :00, the control will beep 3 times followed by one beep every 6 seconds until the TIMER pad is touched.

The 6-second tone can be canceled by following the steps in the Special features of your oven control section under Tones at the End of a Timed Cycle.

_________________________________________________________________________________________

To Reset the Kitchen Timer

If the display is still showing the time remaining, you may change it by touching the TIMER pad, then touch the number pads until the time you want appears in the display.

If the remaining time is not in the display (clock, delay start or cooking time are in the display), recall the remaining time by touching the TIMER

pad and then touching the number pads to enter the new time you want.

_________________________________________________________________________________________

To Cancel the Kitchen Timer

Touch the TIMER pad twice.

(Continued next page)

– 11 –