GE PT925 manual Cooling Fan, Ribbon Cable Assembly, To remove the cooling fan

Models: PT925

1 62
Download 62 pages 42.2 Kb
Page 41
Image 41
Cooling Fan

Cooling Fan

The cooling fan is located in a recess in the back of the oven. It is necessary to remove the oven from the installation to access the cooling fan.

The fan will begin to operate when the oven is in any cooking mode. The fan may continue to operate even after the oven is turned off.

To remove the cooling fan:

1.Remove the main rear access panel. (See Rear Access Panels.)

2.Disconnect the wire harness and the ground wire from the cooling fan.

Disconnect

Cooling Fan

3.Remove the four 1/4-in. hex-head screws (2 on each side) that hold the cooling fan to the control compartment.

4.Carefully grasp the assembly and tilt the unit back, up, and out of the oven frame.

Ribbon Cable Assembly

To remove the ribbon cable assembly:

1.Open or remove the lower door.

2.Release the ribbon cable assembly from the door. (See Door Assemblies.)

3.Remove the secondary rear access panel. (See

Rear Access Panels.)

4.Disconnect the back of the ribbon cable from the mating connector.

Disconnect

5.Remove the 4 screws and nuts from the front end of the ribbon cable housing.

6.Remove the ribbon cable by sliding it out of the ribbon cable sleeve.

Note: When installing the new ribbon cable, ensure that the new cable is positioned between the wings of the ribbon guide located between the oven cavities.

– 41 –

Page 41
Image 41
GE PT925 manual Cooling Fan, Ribbon Cable Assembly, To remove the cooling fan, To remove the ribbon cable assembly