GE PT925 manual To replace the upper inner door assembly, Assembly Notes, Door Gasket

To replace the upper inner door assembly:

1.Remove the upper door assembly. (See Door Assemblies.)

2.Remove the four T15 Torx screws (2 on each side) that attach each door hinge to the inner door. Carefully turn the door over and remove both door hinges.

3.Remove the six 1/4-in. hex-head screws that hold the insulation retainer to the inner door. Remove the insulation retainer.

4.Remove the insulation and the inner glass assembly from the inner door.

Inner Glass Assembly

Assembly Notes

When assembling, make sure the hinges are parallel to each other and perpendicular to the door liner. If not, the hinge may bind on the receiving channel of the door. If the new hinge is not in the cocked and locked position after installing, place the bottom of the door against a firm, protected surface and push the hinge arm down to the cocked position. Pull the hinge lock back against the door liner surface to lock the hinge in this position.

Air enters the door assembly through large slots in the bottom and flows upward between the inner and outer assemblies, exhausting through slots in the top of the door. DO NOT INSULATE THIS AIR CHANNEL.

Door Gasket

The gasket forms a complete seal around the front edge of the oven liner and the inner door panel. The door gasket is attached to the inner door panel by spring clips. When removing the gasket, pull the ends of the gasket out of the slots at the bottom of the door. Place a finger under the gasket beside each clip and pull straight up.

When installing the door gasket, it is helpful to fold the gasket in half and locate the center clip. Insert the clip at the top of the door and work your way around the door.

Make sure the gasket is cross-tucked in the bottom slots of the inner door panel. Use a small screwdriver to tuck the loose ends of the gasket into the slots. The overlap is required to ensure a proper door seal.

Cross Tuck

– 31 –