GE PT925 manual To remove the lower outer door assembly, To replace the door

7.On both sides of the door, press down on the release buttons on each hinge.

Door

Frame

Release buttons

To remove the lower outer door assembly:

1.Remove the lower door. (See Door Assemblies.)

2.Place the inner door assembly, gasket side up, on a protective surface.

3.Remove the four T15 Torx screws from the bottom of the outer door assembly.

8. Lift the door up until it is clear of the hinge.

To replace the door:

1.Firmly grasp both sides of the door at the top.

2.With the door at the same angle as the removal position, seat the indentation of the hinge arm into the bottom edge of the hinge slot. The notch in the hinge arm must be fully seated into the bottom of the slot.

Bottom

4. Remove the two T15 Torx screws (1 on each side) from the outer door assembly.

1 of 2

edge of slot

Hinge arm

Indentation

3.Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.

4.Push the hinge locks up against the front frame of the oven to the locked position.

Hinge lock

Hinge arm

5. Close the oven door.

Note: The inner door assembly is heavier than the outer door assembly.

5.Separate the inner door assembly from the outer door assembly.

6.Remove the four 1/4-in. hex-head screws and brackets that hold the door handle to the outer door assembly.

Door Shown with Inner Door Assembly Removed

Outer Door Assembly

Caution: Care must be taken if reinstalling the door handle. Overtightening the screws can damage the handle. Hand-tighten the screws and make sure the handle fits snugly against the door panel. (Do not use an electric driver.)

(Continued next page)

– 29 –