GE PT925 manual Bake Element, Convection Fan Blade, To remove the bake element

4.Remove the three 1/4-in. hex-head screws that attach the broiler element to the oven cavity.

5.Carefully pull out the sensor approximately 2 inches from the broiler element bracket.

6.Remove the four 1/4-in. hex-head screws that attach the broil element to the top of the oven.

7.Carefully pull, then lower the broiler element towards the front of the oven to remove.

Bake Element

The upper bake element is rated at 1700 watts, and the lower element is rated at 2200 watts.

The bake element terminals are located behind the main rear access panel.

To remove the bake element:

1.Remove the main rear access panel. (See Rear Access Panels.)

IMPORTANT: The lower wattage elements use 3/16-in. terminal connections. The higher wattage elements use 1/4-in. terminal connections.

2. Disconnect the wires from the bake element.

DisconnectDisconnect

3.Remove the two 1/4-in hex-head screws that hold the bake element to the back of the oven.

4.Carefully pull the bake element out through the front of the oven.

Convection Fan Blade

The convection fan blade is located on the back wall of the oven cavity and is removed separately from the convection fan motor.

To remove the convection fan blade:

1.Remove the oven racks.

2.Remove the four 1/4-in. hex-head screws that hold the convection cover to the back wall of the oven cavity.

3.The fan blade is attached to the motor shaft with a reverse-threaded 1/2-in. hex-nut. Turn the nut clockwise to remove.

– 36 –