GE PT925 manual Door Hinge Receivers, Meat Probe and Outlet, Oven Light Assembly

Door Hinge Receivers

To remove the door hinge receivers:

1.Remove the side access panels. (See Side Access Panels.)

2.Carefully lift the insulation from the outside of the oven.

3.Remove the two T20 Torx screws that hold each hinge receiver to the oven frame.

3.Pull the outlet and wiring down from the oven wall.

Note: When replacing the meat probe outlet, cut the probe wires and splice the new probe using approved heat-resistant connectors.

Cut Here Cut Here

4.Push the hinge receiver through the opening in the oven frame and remove from the rear.

Note: Upon reassembly, ensure the displaced insulation around the oven and components is returned to its original position.

Meat Probe and Outlet

The meat probe outlet is located on the top of the oven cavity, near the front. The meat probe outlet is connected to the electronic oven control. The meat probe has a resistance value of 30K-50K Ω at room temperature.

To remove the meat probe outlet:

1.Open the lower oven door.

2.Remove the two 1/4-in. hex-head screws that attach the meat probe outlet to the top of the oven cavity.

Oven Light Assembly

The oven has two light assemblies in each oven cavity. The light assemblies are located on the top rear of the oven. The lights come on when the door is opened or when the oven is in a cooking cycle. The oven lights do not come on during self-cleaning or if the Sabbath Feature is set.

Each light assembly consists of a removable light cover, a light bulb socket, and a light bulb.

To remove an oven light assembly:

1.Remove the main rear access panel. (See Rear Access Panels.)

2.Remove the three 1/4-in. hex-head screws that attach the panel securing the lighting assembly wires to the rear of the oven.

(Continued Next Page)

– 42 –