Operators Guide
Assembly Instructions (continued)
4. Attaching the Engine Mount and Vacuum Assembly
|
|
| Vacuum |
|
|
| Assembly |
Tools Required: |
|
| |
1. | Ratchet |
|
|
2. | 1/2” Socket |
|
|
3. 1/2" Wrench |
|
| |
4. | 9/16” Wrench | Frame |
|
5. | 9/16” Socket |
| |
6. | 7/16” Socket |
| Inlet |
7. Socket Extension | Engine Mount | Cover |
1.Slide the Engine Mount into the Frame as shown.
2.Place the Vacuum Assembly on the Engine Mount and secure it tightly with four (4) 5/16” x
3.Slide the Engine Mount into the Frame so that the Vacuum Assembly is as close to the Frame as as possible.
4.Adjust the Engine Mount to the nearest aligning holes between the Frame and the Engine Mount.
5.Secure the Engine Mount to the Frame with two (2) 3/8” x
6.Place the Inlet Cover on the Vacuum Assembly with the inlet cylinder pointing downward and forward toward the mower deck.
7.Secure the Inlet Cover with six (6) 1/4” flat washers and six (6) 1/4” nylon lock nuts.
NOTE: Auxiliary Engine kits contain a remote throttle cable that is not used with the
10