Operators Guide
Auxiliary Engine Vacuum Assembly Servicing the Engine
1.Make sure that engine oil is at engine manufacturer’s recommended level (refer to engine manual).
2.Fill the fuel tank. Use fresh, clean, unleaded automotive gasoline.
Pre-Start Check
1.Make sure the stop switch is in the OFF position and spark plug wire is disconnected. Pull the starter rope slowly to make certain there are no foreign objects in the blower housing.
2.Be sure the spark plug wire and cover are attached to the spark plug.
Starting the Engine
1.Turn the stop switch to the ON position.
2.Move the choke lever to the FULL CHOKE position.
3.Move the throttle lever to the FULL THROTTLE position.
4.Grasp the starter handle firmly. Pull the handle with a rapid continuous motion.
5.When the engine starts, move the choke to 1/2 choke and then to NO CHOKE position
Operating the Vacuum
1.NEVER USE THE
2.Make sure both hoses are connected at both ends. Inspect hoses prior to each use.
3.Do not use the
4.The mower must be running in order to vacuum debris through the mower deck.
5.In heavy grass it may be necessary to mow and vacuum at a slower ground speed.
6.Never attempt to unclog the
7.Do not stand behind the vent at the rear of the
8.Be sure to wear eye and ear protection.
9.TO STOP THE ENGINE: throttle down to slow for a few seconds, then push switch to OFF. Remove any hearing protection and listen for all moving parts to come to a complete stop. The flywheel in the power head will coast for a few seconds after the engine is shut off before actually stopping.
13