SERVICE AND ADJUSTMENTS
VIEWED FROM L.H. SIDE OFTRACTOR
CLUTCHING
IDLER
"_NGINEBELT
CLUTCHING
FLAT IDLER
BELT KEEPER
KEEPER | BELT |
| |
| TWISTS |
| |
ENGINE | BELT | TRANSAXLE | |
KEEPER | PULLEY | ||
PULLEY | |||
|
|
AS VIEWED FROM BOTTOM
FIG. 26
TRANSMISSION REMOVAL/REPLACEMENT
Should your transmission require removal for service or replacement, it should be purged after reinstallation and before operating the tractor, See"PURGETRANSMISSION" in the Operation section of this manual.
TO ADJUST STEERING WHEEL ALIGN- MENT
If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straightforward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual,
FRONT WHEEL TOE-IN/CAMBER
The front wheel
TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig. 27)
•Block up axle securely.
•Remove axle cover, retaining ring and washers to allow wheel removal.
•Repair tire and reassemble,
•Replace washers and snap retaining ring securely in axle groove,
•Replace axle cover.
REAR WHEEL -
•Block rear axle securely,
•Remove five (5) hub bolts to allow wheel removal,
•Repair tire and reassemble. Replace and tighten hub bolts securely,
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer, Tire sealant also prevents tire dry rot and corrosion.
WASHERS
RETAINING
RING
AXLE
COVER
,Q
FIG. 27
TO START ENGINE WITH A WEAK BATTERY (See Fig. 28)
&WARNING:
batteries. Always wear eye protection when around batteries.
If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).
If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT:YOURTRACTORIS EQUIPPEDWITH A 12VOLT SYSTEM.THE OTHER VEHICLE MUST ALSO BE A 12 VOLT
SYSTEM.DO NOTUSEYOURTRACTORBATTERYTO START OTHERVEHICLES.
TO ATTACH JUMPER CABLES -
•Connect one end of the RED cable to the POSITIVE
(+)terminal of each
•Connect one end of the BLACK cable to the NEGATIVE
•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
•BLACK cable first from chassis and then from the fully charged battery.
•RED cable last from both batteries.
DD
| 02614 |
WEAK OR DEAD | FULLY CHARGED |
BATTERY | BATTERY |
| FIG. 28 |
24