Husqvarna 917.29939 Service and Adjustments, Tiller, To Adjust Handle Height See Fig, Narrow

SERVICE AND ADJUSTMENTS

CAUTION: Disconnect spark plug wire from contact with plug.

TILLER

TO ADJUST HANDLE HEIGHT (See Fig. 15)

Factory assembly has provided lowest handle height. Select handle height best suited for your tilling conditions. Handle height will be different when tiller digs into soil.

•If a higher handle height is desired, loosen the four nuts securing handle panel to engine brackets.

•Slide handle panel to desired location.

•Tighten the four nuts securely.

spark plug and place wire where it cannot come into

MID=WIDTH TILLING =24 INCH PATH (See Fig. 17)

•Assemble holes '_'in tine hubs to holes "C" in tine shaft.

ENGINE		Fig. 17
BRACKETS
HANDLE	NARROW	TILLING/CULTIVATING - 12-3/4 INCH PATH
PANEL	(See Fig.	18)
	• Remove outer tines.
NUTS (ALSO	2
ON LEFT SIDE

OF TILLER)

•	w===_	IP==4	•
oil		I Io

ool

tine 6

Fig. 15

TINE ARRANGEMENT

Your outer tines can be assembled in several different ways to suit your tilling or cultivating needs.

iCAUTION: Tines are sharp. Wear

gloves or other protection when han= dling tines.

NORMAL TILLING = 26 INCH PATH (See Fig. 16)

•Assemble holes '_'in tine hubs to holes "B" in tine shaft.

INNER TINES ONLY

Fig. 18

NOTE: When reassembling outer tines, be sure right tine assembly (marked "R") and left tine assembly (marked "1") are mounted to correct side of tine shaft.

HAIRPIN CLIP INNER TINE

Fig. 16

13