NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car- buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).
CYLINDER
1.Remove spark plug.
2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.
3.Pull starter handle slowly a few times to distribute oil.
4.Replace with new spark plug.
OTHER
•Do not store gasoline from one season to another.
•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.
•If possible, store your unit indoors and cover it to protect it from dust and dirt.
•Cover your unit with a suitable protec- tive cover that does not retain moisture. Do not use plastic. Plastic cannot breathe, which allows condensation to form and will cause your unit to rust.
IMPORTANT: Never cover mower while engine and exhaust areas are still warm.
CAUTION: Never store the lawn mower with gasoline in the tank inside a building where fumes may reach an open
flame or spark. Allow the engine to cool before storing in any enclosure.
TROUBLESHOOTING - See appropriate section in manual unless directed to a Husqvarna Parts & Repair Center.
PROBLEM |
| CAUSE |
| CORRECTION |
Does not start | 1. | Dirty air fi lter. | 1. | Clean/replace air fi lter. |
| 2. | Out of fuel. | 2. | Fill fuel tank. |
| 3. | Stale fuel. | 3. | Empty fuel tank and refi ll tank |
|
|
|
| with fresh, clean gasoline. |
| 4. | Water in fuel. | 4. | Empty fuel tank and refi ll tank |
|
|
|
| with fresh, clean gasoline. |
| 5. | Spark plug wire disconnected. | 5. Connect wire to plug. | |
| 6. | Bad spark plug. | 6. | Replace spark plug. |
| 7. | Loose blade or broken | 7. | Tighten blade bolt or |
|
| blade adapter. |
| replace blade adapter. |
| 8. | Control bar in released | 8. | Depress control bar to |
|
| position. |
| handle. |
|
|
|
|
|
18
