TO EMPTY GRASS CATCHER
1.Lift up on grass catcher using the frame handle.
2.Remove grass catcher with clippings from under lawn mower handle.
3.Empty clippings from bag.
NOTE: Do not drag the bag when empty- ing; it will cause unnecessary wear.
Grass catcher frame 
handle
BEFORE STARTING ENGINE
ADD OIL
Your lawnmower is shipped without oil in the engine. For type and grade of oil to use, see “ENGINE” in the Maintenance section of this manual.
CAUTION: DO NOT overfill engine with oil, or it will smoke heavily from the muffler on startup.
1.Be sure lawnmower is level.
2.Remove oil dipstick from oil fill spout.
3.You receive a container of oil with the
unit. Slowly pour the entire container down the oil fill spout into the engine.
NOTE: Initial oil fill requires only 18 oz. due to residual oil in engine from the manufacturers 100% quality testing. When changing oil you may need 20 oz.
4.Insert and tighten dipstick.
IMPORTANT:
• Check oil level before each use. Add oil if needed. Fill to full line on dipstick.
• Change the oil after every 25 hours of operation or each season. You may need to change the oil more often under dusty, dirty conditions. See “TO CHANGE ENGINE OIL” in the Mainte- nance section of this manual.
ADD GASOLINE
•Fill fuel tank to bottom of tank fi ller neck. Do not overfi ll. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gasoline. Pur- chase fuel in quantities that can be used
within 30 days to assure fuel freshness. 
CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.
CAUTION: Alcohol blended fuels (called gasohol or using ethanol or metha- nol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Empty the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.
Gasoline filler cap
Engine |
|
oil cap | Primer |
TO STOP ENGINE
•To stop engine, release operator pres- ence control bar.
TO START ENGINE
NOTE: Due to protective coatings on the engine, a small amount of smoke may be present during the initial use of the product and should be considered normal.
NOTE: Your engine is equipped with an automatic choke system. No priming or choking is required before starting.
•To start engine, hold operator presence control bar down to the handle and pull starter handle quickly. Do not allow starter rope to snap back.
PARTKEY | DESCRIPTIONNO.NO. | (IncludesAssemblyHandleUpper1999821 Foam Grip) 29 191221 Cable, Operator Presence LowerHandle,193664X498230 189179 Blade Adapter / Pulley RHDoor,RearSpring,405416331 406712 Blade, 21" GuideRope194788432 851074 Washer InsertLockwasherwithHex,Nut,1320045 | componentAllNOTE:dimensions given in U.S. inches. 1 inch = 25.4 mm. replacement(O.E.M.)ManufacturerEquipmentOriginalonlyUseIMPORTANT:parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty. | |
|
| DESCRIPTION |
|
|
| PART | NO. |
|
|
| KEY | NO. |
|
|
10 | 39 |
