Transmission | Husqvarna 960430120 specs

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 35)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

07002

Fig. 35

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjust- ment should not be necessary. If adjustment is necessary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

TRANSMISSION

REMOVAL/REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and beforeoperatingthetractor. See“PURGETRANSMISSION” in the Operation section of this manual.

23

Image 23

Husqvarna 960430120 owner manual Transmission

Contents

YTH21K46 II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General Operation IV. Towing ServiceGeneral Service III. Children Table of Contents Toremovetractorfromcarton AssemblyTools Required for Assembly Unassembled Parts Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL Belts Operation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See Fig To USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Move Forward and Backward See Fig To Operate on Hills Service REMINDER/HOUR MeterUsing the Reverse Operation System Reverse Operation System ROS See Fig To Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD Gasoline Purge Transmission Mowing Tips Schedule MaintenanceMaintenance General Recommendations Blade Removal See Fig BatteryTractor Blade Care Engine Deck Washout Port See Fig CleaningSpark Plugs IN-LINE Fuel Filter See Fig To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Visual SIDE-TO-SIDE Adjustment See Fig To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check Brake To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigReplacing Battery See Fig Front Wheel TOE-IN/CAMBER Transmission Engine OIL StorageOther Fuel System Problem Cause Correction Troubleshooting Points Engine continues Tractor - Model Number YTH21K46 96045002901, Product no 45 Schematic Tractor - Model Number YTH21K46 96045002901, Product no 45 KEY Part Description Electrical Chassis Tractor - Model Number YTH21K46 96045002901, Product no 45 Drive Tractor - Model Number YTH21K46 96045002901, Product no 45 Engine Spark Arrester KIT Tractor - Model Number YTH21K46 96045002901, Product no 45 Steering Assembly Tractor - Model Number YTH21K46 96045002901, Product no 45 Mower Deck KEY Part NO. no Description 100 101 Mower Lift 532 43 Seat Seat Assembly Wheels and Tires Decals Suggested Guide for Sighting Slopes for Safe Operation 05.18.11 CL