To Replace Headlight Bulb, To Replace Fuse | Husqvarna 96045000901

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 38)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

02778

FIG. 38

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

25

Image 25

Husqvarna 96045000901 To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse, To Adjust Throttle Control Cable

Contents

YTH2348 Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope Operation III. Children ServiceIV. Towing Table of Contents Tools Required for Assembly AssemblyUnassembled Parts To Remove Tractor from Carton Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake System Operation Reverse Operation System ROS on Position Know Your Tractor Stopping HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo Move Forward and Backward See Fig To USE Cruise Control J See Fig Using the Reverse Operation System Service REMINDER/HOUR MeterReverse Operation System ROS See Fig To Operate on Hills Check Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See Fig Purge Transmission Mowing Tips Lubrication Chart Maintenance Tractor BatteryBlade Care Brake Operation Belts EngineTransaxle Cooling Transaxle Pump Fluid Cleaning To Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig First Install ANTI-SWAY BAR S LBF To Level Mower To Replace Mower Blade Drive Belt See Fig Mower Drive Belt InstallationMower Drive Belt Removal To Replace Motion Drive Belt See Fig Belt InstallationTo Check Brake Front Wheel TOE-IN/CAMBER Replacing Battery See Fig To Start Engine with a Weak BatteryTo Remove Wheel for Repairs See Fig To Attach Jumper Cables To Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight Bulb Other StorageFuel System Engine OIL Troubleshooting Points Engine dies when Tractor Model NO. YTH2348 96045000901, Product no 45 Schematic Electrical KEY Part Description Chassis Tractor Model NO. YTH2348 96045000901, Product no 45 197 196 Drive Tractor Model NO. YTH2348 96045000901, Product no 45 Engine Spark Arrester KIT Engine Power Rating Information Steering Assembly 532 40 Seat Seat Assembly Mower Deck 532 40 Deck Weldment Mower Mower Lift Wheels and Tires Decals Service Notes Service Notes Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation Warranty Statement