Husqvarna 532 43 86-44 Anti-Sway Bar S, Turn Steering Wheel Left and Position Mower See Fig

SERVICE AND ADJUSTMENTS

2.ASSEMBLE FRONT GAUGE WHEEL (W) TO FRONT OF MOWER (See Fig. 22)

5.INSTALL ANTI-SWAY BAR (S) (IF EQUIPPED) (See Fig. 25- 27)

H W

X

Z Y

H.FRONT MOWER BRACKET

W. FRONT GAUGE WHEEL

X.SHOULDER BOLT

Y.1-1/4 O.D.

WASHER

Z.3/8-16 LOCKNUT

ANTI-SWAY BAR (S)
TOWARDS	TOWARDS
TRANSAXLE	MOWER DECK
90° END	INTEGRATED WASHER END

Fig. 25

Fig. 22

3.TURN STEERING WHEEL LEFT AND POSITION MOWER (See Fig. 23)

•Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield (Q) to the right.

FRONT

Q

ENGINE

TRANSAXLE

Q. DEFLECTOR

BACK02965SHIELD

Fig. 23

4. SLIDE MOWER UNDER TRACTOR (See Fig. 24)

•Bring belt forward and check belt for proper routing in all mower pulley grooves.

NOTE: Be sure mower side suspension arms (A) are point- ing forward before sliding mower under tractor.

•Slide mower under tractor until it is centered under tractor.

		Q
	A	A. MOWER SIDE
		SUSPENSION
		ARMS
		Q. DEFLECTOR
02965		SHIELD

Fig. 24

•From right side of mower, first insert 90° end of anti-sway bar (S) into hole in transaxle bracket (T), located near left rear tire in front of transaxle.

NOTE: Flashlight may be helpful.

ANTI-SWAY BAR	TRANSAXLE
(S) LOCATION	BRACKET (T)

LOCATED

BETWEEN REAR

TIRES

	S
T	S. ANTI-SWAY BAR
	T. TRANSAXLE BRACKET

Fig. 26

NOTE: Depending on model, bracket (T) may be differ- ent than shown but hole for anti-sway bar will be in same position/location.

•Pivot the integrated washer end of anti-sway bar (S) towards mower deck bracket on right side of mower. Insert integrated washer end of bar into hole in rear mower bracket (D). Move mower as needed to insert integrated washer end of bar into rear mower bracket (D).

•Secure with small washer and small retainer spring as shown.

		D. RIGHT SIDE
			REAR MOWER
	T	S	BRACKET
		S. ANTI-SWAY BAR
D		T.	TRANSAXLE
			BRACKET

Fig. 27

19