Husqvarna 961 45 00-05 01, 532 41 44-89 owner manual Engine, AIR Filter, Muffler, Spark Plug

ENGINE

LUBRICATION

Use only high quality detergent oil rated with API service classification SG–SL. Se- lect the oil's SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

							SAE 30
			5W-30
F	-20	0			30 32 40		60	80	100
C	-30	-20		-10	0	10	20	30	40

TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, these multi-viscosity oils will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil. Change the oil after every 25 hours of op- eration orat least once a year if the mower is not used for 25 hours in one year. Check the crankcase oil level before starting the engine and after each five (5) hours of continuous use. Tighten oil plug securely each time you check the oil level.

TO CHANGE ENGINE OIL

NOTE: Before tipping lawn mower to drain oil, empty fuel tank by running engine until fuel tank is empty.

1.Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

2.Remove engine oil cap; lay aside on a clean surface.

3.Tip lawn mower on its side as shown and drain oil into a suitable container. Rock lawn mower back and forth to re- move any oil trapped inside of engine.

7.Continue adding small amounts of oil, rechecking the dipstick until oil level settles at FULL. DO NOT overfill, or engine will smoke heavily from the muffler on startup.

8.Always be sure to retighten oil dipstick before starting engine.

9.Reconnect spark plug wire to spark plug.

AIR FILTER

Your engine will not run properly and may be damaged by using a dirty air filter. Replace the air filter cartridge every 100 hours of operation or every season, whichever occurs first. Service air cleaner more often under dusty conditions.

TO CLEAN AIR FILTER

1.Loosen screw and tilt cover to remove.

2.Carefully remove cartridge.

3.Clean by gently tapping on a flat sur-

face. If very dirty, replace cartridge. CAUTION: Petroleum solvents, such as kerosene, are not to be used to clean cartridge. They may cause deterioration of the cartridge. Do not oil cartridge. Do not use pressurized air to clean or dry cartridge.

4.Install cartridge, then replace cover making sure the tabs are aligned with the slots in the back plate. Fasten screw securely.

Lip Back plate

Cartridge

Slot

		Cover
		Cover	tab
		MUFFLER
		Inspect and replace corroded muffler as it
	Container	could create a fire hazard and/or damage.
4.	Wipe off any spilled oil from lawn	SPARK PLUG
	mower or side of engine.
5.	Slowly pour oil down the oil fill spout,	Replace spark plug at the beginning of
	stopping every few ounces to check the each mowing season or after every 100
	oil level with the dipstick.	hours of operation, whichever occurs
6.	Stop adding oil when you reach the	first. Spark plug type and gap setting
	FULL mark on the dipstick. Wait a	are shown in the “PRODUCT SPECIFIC-
	minute to allow oil to settle.	14 ATIONS” section of this manual.