Briggs & Stratton Power Products Home Generator
Installation Manual
INSTALLATION PROCEDURES
Required Specialty Tools/Equipment
•Two 48” lengths of 1” OD pipe (NOT conduit)
•Hole punches for 16ga steel
•Torque screwdriver, 5 to 50
Unpacking Precautions
The unit is shipped bolted to its mounting pad, ready for installation. Avoid damage from dropping, bumping, collision, etc. Store and unpack carton with the proper side up, as noted on the shipping carton.
CAUTION
Installing the 15A fuse could cause the engine to start.
•Observe that the 15 Amp fuse has been removed from the control panel for shipping.
•DO NOT install this fuse until all plumbing and wiring has been completed and inspected.
Delivery Inspection
After removing the carton, carefully inspect the Home Standby Generator for any damage that may have occurred during shipment.
IMPORTANT: If loss or damage is noted at time of delivery, have the person(s) making delivery note all damage on the freight bill and affix his signature under the consignor's memo of loss or damage. If loss or damage is noted after delivery, separate the damaged materials and contact the carrier for claim procedures. Missing or damaged parts are not warranted.
Shipment Contents
The Home Standby Generator is supplied with:
•Home Standby Generator
•
•One 24” flexible
•Installation and
•Operator’s manual(P/N 192384GS)
•Illustrated parts list manual (P/N 193208GS for model 01815 or P/N 193918GS for model 01938)
•Installation checklist (P/N 190840GS)
•Three access door keys
•Four lifting hole plugs
•Oil fill spout
•
•One spare 15A fuse
•Diagnostic LED kit (diode/plate/decal/pin connectors (2))
Home Standby Generator Location
Before installing generator, consult with homeowner and convey the following guidelines which may affect the desired location.
Generator Clearances
WARNING
Exhaust heat/gases can ignite combustibles or structures causing a fire.
•Keep at least 5 ft. (152 cm) clearance on all sides of generator including overhead.
Place generator in a well ventilated area, which will allow for removal of deadly exhaust gas. DO NOT install generator where exhaust gas could accumulate and enter inside or be drawn into a potentially occupied building. Ensure exhaust gas is kept away from any windows, doors, ventilation intakes or other openings that can allow exhaust gas to collect in a confined area (Figure 1). Prevailing winds and air currents should be taken into consideration when positioning generator.
Using a generator indoors WILL KILL YOU IN MINUTES.
Exhaust contains carbon monoxide, a poison gas you cannot see or smell.
NEVER use in the home ONLY use outdoors and
or in partly enclosed far from open windows, areas such as garages. doors, and vents.
General Location Guidelines
•Install the unit outdoors ONLY.
•Place the unit in a prepared location that is flat and has provisions for water drainage.
•Install the unit in a location where sump pump discharge, rain gutter down spouts, roof
4
